AD1000
Plug-in module EV/VE/DD1000
- Helps reduce installation time
- Up to 32 addresses can be set
- Fits into motion sensor connector block
- Supported by ATS1290N DGP
Related products
At a glance
The AD1000 IADS module is supported by the ATS1290N DGP, and designed to be installed directly on the terminal block of the following detectors: EV1000 series / VE1000 series / DD1000 series (standard as well as AM variants).
A 3 core connection only is required to the ATS1290N DGP / ATS Master panel.
As the AD1000 acts as I/O interfaces with one dual-zone input and two outputs, it is necessary to program anti-masking detectors to signal a technical fault or
antimasking condition to the alarm output.
A 3 core connection only is required to the ATS1290N DGP / ATS Master panel.
As the AD1000 acts as I/O interfaces with one dual-zone input and two outputs, it is necessary to program anti-masking detectors to signal a technical fault or
antimasking condition to the alarm output.
Details
- Helps reduce installation time
- Up to 32 addresses can be set
- Fits into motion sensor connector block
- Supported by ATS1290N DGP
Technical specifications
| General | ||
|---|---|---|
| Accessory group |
Motion sensors
|
|
| Type |
Module
|
|
| Electrical | ||
|---|---|---|
| Operating voltage |
9 to 24 VDC
|
|
| Current consumption |
200 mA (Max. current capacity output day/night)
200 mA (Max. current capacity output walk test)
max. 900 µA, 900 µA (Max. current consumption at 13.4 VDC)
400 µA (Min. current consumption at 13.4 VDC)
approx. 75 µA (Bus current consumption out of bus)
|
|
| IADS-bus voltage | ||
|---|---|---|
| 12 or 24 VDC | ||
| Device type / Category | ||
|---|---|---|
| T3 / PIR | ||
| Address range | ||
|---|---|---|
| 0 to 31 | ||
Downloads
All downloadsDatasheet
Installation sheet
Certificates
If available, the downloads of the Certificates, Software & Firmware and Media are displayed in their default language.